Modifier and Type  Field and Description 

static double 
curveCollinearityEpsilon
If the distance between a point and a line is less than
this constant, then we consider the point lies on the line.

static double 
distanceToleranceManhattan
The Manhattan distance is used in the case when either the line
((x1, y1), (x4, y4)) passes through both (x2, y2) and (x3, y3)
or (x1, y1) = (x4, y4).

static double 
distanceToleranceSquare
In the case when neither the line ((x1, y1), (x4, y4)) passes
through both (x2, y2) and (x3, y3) nor (x1, y1) = (x4, y4) we
use the square of the sum of the distances mentioned below in
compare to this field as the criterion of good approximation.

Constructor and Description 

BezierCurve(List<Point2D> controlPoints)
Constructs new bezier curve.

Modifier and Type  Method and Description 

List<Point2D> 
getBasePoints()
Treat base points as the points which are enough to construct a shape.

List<Point2D> 
getPiecewiseLinearApproximation()
You can adjust precision of the approximation by varying the following
parameters:
curveCollinearityEpsilon , distanceToleranceSquare ,
distanceToleranceManhattan 
public static double curveCollinearityEpsilon
public static double distanceToleranceSquare
public static double distanceToleranceManhattan
public List<Point2D> getBasePoints()
getBasePoints
in interface Shape
List
consisting of shape's base points.public List<Point2D> getPiecewiseLinearApproximation()
curveCollinearityEpsilon
, distanceToleranceSquare
,
distanceToleranceManhattan
List
containing points of piecewise linear approximation
for this bezier curve.Copyright © 1998–2017. All rights reserved.